cnc flybar cage problems

[odieser]

The cnc flybar cage seems to have a bit of lateral movement on the flybar seesaw.
The cage is a few millimeters wider than the seesaw. Should I just leave it as is or add some washers on the flybar between the cnc cage and the plastic seesaw to shore up the movement?
I wish Gaui would have manufactured this part in cnc as well.
Thanks in a avance to any help given.
Mark

[tornet999]

I have same problem, flying with it cage as is, seems to not cause any problems.

[odieser]

I was only curious even a couple of millmeters may cause a imbalance in the flybar when spinning

[Mikej]

The cnc flybar cage seems to have a bit of lateral movement on the flybar seesaw.
The cage is a few millimeters wider than the seesaw. Should I just leave it as is or add some washers on the flybar between the cnc cage and the plastic seesaw to shore up the movement?
I wish Gaui would have manufactured this part in cnc as well.
Thanks in a avance to any help given.
Mark

I don't have the CNC cage, but I have a similar cage on my T-Rex 450 that also is slightly too wide. I don't know if this causes a problem but it didn't seem correct so I spaced it out with 2 small washers - works fine

[odieser]

thanks I will try that

[tungym]

There should be 2 washer from the old plastic seesaw. I lost mine and I use some 3mm tiny washer instead.