Raptordude
03-04-2005, 09:25 AM
Ok guys, I was told I can run 6 volts through my JR 500T and 510G tailrotor servo. Can the Throttle Jockey Pro handle 6 volts as well? What cant you run 6 volts through? If I cant run 6 volts, what do I need to regulate it down to? I have seen 5.1 volt and one other volt regulator before. Thanks for your helps guys.
sdixon747
03-05-2005, 01:47 AM
I know that some electronics don't like the 6 volts for long. I know there is a big debate about this, but my opinion on this is, you will get a small performance increase with faster servo times, however, the failure rate is higher. I don't believe the small performance gain is worth the higher risk of failure. I use Duralites with a 5.1 failsafe switched regulator. Hope this helps.
Steve