9CHP + GV1 Throttle Hold

[ntwaddell]

I have my GV1 connected to three channels..

SW(F) turns the GV1 on and off
SW(E) switches speed 1, 2 and 3.

So if i want to set like SW(H) to throttle hold. I assume I need to switch off the GV1 first, then bring it to an idle.

How do i go about doing this?

Thanks!

[Skybolt]

I have a similar setup. I use the Normal-Idle1-2 switch to control speed, so you can have 3 differents speed setting.

I disable Idle3 function and used that switch on chanel 8 to turn on and off the GV-1.
If you have all your direction correctly set when you flip the throtle hold switch the GV-1 will disengage.

You can check it out by using the servo menu on the 9c and confirm with the SWcd funtion on the GV-1.
And it works in real life for me.