Lipo receiver pack for AR6100?

[racin06]

I've been watching Finless Bob's setup videos for the T-Rex 450. I'm getting ready to setup both my Esky Belt CP and Mini-Titan E325. For safety reasons, I'd like to power my AR6100 directly from a lipo battery in order to set up the servos. My question is what type lipo receiver pack do you recommend? I'm a little confused on the voltage and mAh requirements. I want to stick to a lipo since I already own a lipo charger/balancer. Thanks.

[bullaculla]

you can plug any 2s lipo directly into the 6100. I've even plugged in the lipo to the RX using the BEC type plugs :)

[turboomni]

Whats wrong with using an old 4.8 volt rx pack you have lying around/?

[bcritch]

I was just trying to figure this out my self, by having 3 channels taken by cyclic servos, and 2 by the tail servo and gyro gain, and another by the throttle, then you can plug your battery into the battery port, but then any time you re-bind, how do you do that, because you need your reciever to be powered up, but if you are using your battery port for the battery, then how can you bind? I hope I have not lost anyone her with this, and I am not trying to take over anyone elses post, but if anyone can help that would be great.

[Awais]

You can either power up using the ESC/BEC, or unplug any one of the channels and plug a battery in there. You can power up the receiver by plugging in the battery into any of the channels.

Awais

[racin06]

you can plug any 2s lipo directly into the 6100. I've even plugged in the lipo to the RX using the BEC type plugs :)

Thanks...what about my servos? Will the servos (stock Esky micro servos) be able to handle the voltage?