charging 2x3s polyquest on bc6 charger

[mkc2]

Any one charging 2x3s polyquest packs on a bantam bc6, looking for diagram to make v harness.
any help , thanks

[theglennster]

Hi mkc2
I've done it with Flightpower packs see my post here this should give you some pointers I should imagine its similar to this :-

http://www.helifreak.com/showthread.php?t=43505

I would take note not to cross the polarity or you can short the packs, be careful. :thumbup:

Cheers
Glenn

[mkc2]

Thanks for your reply.
Have seen your post but need to be very clear on this as there is no second chance.
This is what im trying to do,balance lead needs to be clipped in but not 100% on connections.
I have seen other wired balance leads but not the bc6, as others seem to have 7,8 or 9 wires.
polyquest is the same as awesome power batteries, if that helps (balance plug)

This is the board i have, a lot different to your setup.
any help is better then none.