HB fp and GWS dd tail

[rsking45]

Hello all,
I have a honey bee fp heli,That I installed this kit on.The problem that I am having is that after i start to spool up the tail motor kicks in and the tail of the heli will only spin very fast to the right(Tail right nose to the left) and I have no controll over it,using the rudder stick .The only way to get the tail to stop is to throttle all the way down.
I have done some mods befor this and had no problems the tail held great.
As far as mods ,if you would call them mads are,I took the 3in 1 and the g90 gyro off my cpp and installed them on my HB so I can use the dx6 tx and rx,which has been great.
Any ideas?
Thanks Rich

[JasonJ]

Make sure the prop is oriented correctly on that dd tail motor, and make sure the tail rotor is turning in the right direction. The only way the heli is going to spin as you describe is if the tail rotor is spinning the wrong way or if it is just not strong enough to counteract the torque from the main rotor.

[rsking45]

I switched the tail motor wire go to the 3in1+to- -to + and it is working great.It holds the tail really well.I should have done this mod along time ago.
Thanks