View Full Version : speed controller question, himax, phoenix
bluealien
03-13-2005, 12:39 PM
hi all, i have a question... I'm using a phoenix -25 speed controller with my 2025-4200 himax brushless, I've seen combo deals of the himax 2025 being sold with the phoenix - 35. which one is correct?
capebob
03-13-2005, 07:51 PM
The -25 is adequate for the 2025-4200. It's the one I use. Many are using th -35 because it is claimed that there is less tail wag using this controller. I don't know abut that.
Bob
Kenji
03-14-2005, 09:58 AM
I too am using the Ph-25 with the himax 20215-4200 and I have no problem. Good Luck
Hotshot Charlie
03-14-2005, 10:04 AM
Ph25 and 2025-4200 on plank and had it in a Shogun also. Worked fine.
DLWoodie
05-15-2006, 06:05 PM
I used to use the 25 with that motor and had no problems. Recently I switched to the 35, and had lots of problems with interference that I never had with the 25, it's a common problem in the forums.
Unless you have changed the servo position and tail gearboxes then wag caused by esc is the least of your worries.
darkside212
08-24-2006, 08:13 AM
The 25 is perfect for the shogun...the 35 is overkill :rolleyes: