Gyro bounce 1 side only

[3secondsToImpact]

Have a problem that is driving me nuts.
The problem in question is on my Trex600, 8s power with a Csm 560 micro ver. 4 gyro feeding a new Jr 8900g servo( headspeed 2100 rpm)
Tail will lock solid when i turn right, but left turn there is a 2 to 3 inch bounce(side to side) then it locks solid, running in headlock mode, but when in rate mode it has no side to side bounce. gain setting in HH mode is 75 to 80% and the same for rate mode.
Any help would be greatly appreciated.
Thanks
Chris

[LAMAR COOLEY]

Hello
Interestingly I had this problem with the logictech 6100 gyro running the logictech servo.
I found that my gain settings were to high in HH. Bringing the HH gain down to 55
solved my problem.
However I am curious, What I know of gyros is that 0 to 50 is usually " normal " mode
and 50 to 100 is " heading hold ".
I must admit I am not acquainted with your gyro.
I hope this may be of some help.

[3secondsToImpact]

Thanks for the reply, i will lower gain to see if helps.
As i understand this gyro is 50 to 0% increases Smartlock mode gain and 50 to 100% increases rate mode.
I can change many perimeters and will bring gain down, i think its about 70% or so now.
Thanks and fly safe