ar7000 just quit working

[cyanide1973]

Hey just wondering if anyone has had this problem. I was setting up my raptor 50 and everything was working good , then the next time i turned it on the light on the main receiver was not coming on and the satellite would blink once then go off. When i tried to rebind it the satellite was blinking like normal but still no light on the main. Is the main receiver fried and if it is why is the satelite still getting power. If anyone could help i would appreciate it.

Thanks

[fllyer]

Try turning on the Tx then hold the bind button in, then turn on the Rx.

If that doesn't work I have no idea.

[joehelicopter]

Hey just wondering if anyone has had this problem. I was setting up my raptor 50 and everything was working good , then the next time i turned it on the light on the main receiver was not coming on and the satellite would blink once then go off. When i tried to rebind it the satellite was blinking like normal but still no light on the main. Is the main receiver fried and if it is why is the satelite still getting power. If anyone could help i would appreciate it.

Thanks

Move the transmitter a few feet away from the aircraft it may be swamping the rec.

[jeffk]

I second what joehelicopter said. It's possible to get the transmitter too close to the receiver and it will cause this exact kind of issue. Generally a foot or so of separation is enough.

[BarnOwl]

Did you try a re- bind?

[cyanide1973]

I tryed holding the transmitter farther away but with no luck and rebinding didn't help. After talking to tec support I sent it of to get fixed hopefully it will be covered under warranty.

Thanks for the help