My first Nitro is a Knight 50 3D!!!!!

[brovic777]

I finally ordered my very first nitro ever today by purchasing a Knight 50 3D!!!

I still have to figure out the rest of the stuff I need to finish the build.

I already have this to use for my setup:

Ace DS1015 servo's
uBEC
GY611 w/s9256

I still need to order this:

OS Hyper 50 motor
Align 2 in 1 regulator?
pipe?
gov?
battery?
starter?
600mm CF Blades?

Anything else I need???

[BigVanVader]

I would hold off on the 2 in 1 until Align releases the new version....The original has some reported issues.

[brovic777]

I would hold off on the 2 in 1 until Align releases the new version....The original has some reported issues.

It has issues with the Futaba recievers, which the updated version will correct.

Do you happen to know when the upgated version will be release.???

Thanks

[DavidH]

Just get a Duralite setup. Battery, regulator with safety switch. Get the 5.6 volt regulator. Battery in a 50 I would suggest the 2900 mah 4 cell pack.

Hatori 50 JK muffler
600 or 620 mm V Blades
Governor, really not a nessicity. Throttle curves will work fine. But if you must have a governor, the Futaba GV1 is probably one of the most user friendly.
You will need a fuel pump setup to get fuel in and out of heli tank.
Need a glow plug igniter to light the plug while the engine is started.
David