nem3
10-13-2007, 12:24 AM
Selling my YS91 combo. Engine has a brand new piston, sleeve and ring installed. The last piston chipped just above the ring. Bearings have a couple gallons on them, as well as the all the gaskets and the plunger for the regulator section. All was replaced this year. Viperhead is installed, but I am including the original head. Hatori SB-16FH has a couple small dings, none can be seen when installed as they are on the mechanics side of the muffler. The Silicon grommets are new, along with the alu spacers. 3 out of the 4 screw holes in the header peice are stripped and require nuts for installation. Little bit of a pain, but it should have been done that way from the get go.
Selling all three pieces as a package for $325 shipped. Will not seperate.
Warning: Even though this is a used motor. You WILL need to break it in. All I did was install the new piston, ring and liner. I have not run the engine at all. You will basically be receiving a new motor
Pics can be found here : http://www.hd3dmedia.com/ys91st4.html
Selling all three pieces as a package for $325 shipped. Will not seperate.
Warning: Even though this is a used motor. You WILL need to break it in. All I did was install the new piston, ring and liner. I have not run the engine at all. You will basically be receiving a new motor
Pics can be found here : http://www.hd3dmedia.com/ys91st4.html