Futaba 9CH Super and R9SDP Reciever Help

[scubaphil]

I was trimming the heli and then i messesed something up so i reset the transmitter and now i get no movement on any of the servos. Please help.

[xrbcoronalogoflyer]

when you said you 'reset the transmitter', you turned it off? go back to the model you were working on and scroll through the settings...take a look at pcm/ppm setting...might have changed...
-ken

[scubaphil]

no,I reset the parameters, like I reset all the settings to factory.. and now nothing works, no servo movement or anything.

[xrbcoronalogoflyer]

i use a 9chps for my raptors, but i'm not too good at explaining the setup--even to myself! this link is very good, and includes the 9c for each step of the transmitter setup...hope it helps...ken

http://www.raptortechnique.com/radiosetup.htm

[BarracudaHockey]

Go into the Parameter menu and make sure modulation is set to PCM, if you have to change it, power cycle the transmitter then try it.

[scubaphil]

thank you for the advice, i will try it as soon as i get the Rx battery charged up again. For a T-Rex 600, what should the "type" be set to on the transmitter??...sorry for all these questions, i'm new at this and i'm still loking for someone to help me. (thank god for theses forums)

[BarracudaHockey]

Sr3

[scubaphil]

Andy, thank you so much for that information. It worked. Anyway, i charged the Rx battery so that i can finish trimming the heli and when i turned on the bec, the lights came on the went of and now it will not turn on anymore. could i have burned it out?...i hope not