Radion Setup for BLade CP

[CompuFoil]

I just got a used Blade CP, and I'm at a total loss on how to set the servos up. If I set the reverse switches so that the elevator and aileron go the right direction, then I get negative pitch when I spool up!? What am I missing here? It has a separate HH gyro, separate ESC, and the stock 3in1 (I guess thats what it is).
Eric

[=-C°G-=]

I just got a used Blade CP, and I'm at a total loss on how to set the servos up. If I set the reverse switches so that the elevator and aileron go the right direction, then I get negative pitch when I spool up!? What am I missing here? It has a separate HH gyro, separate ESC, and the stock 3in1 (I guess thats what it is).
Eric

Hi Eric,
If it is the stock plastic head. Check the blade grips maybe? The Allen head bolt should pass through from the top with the nut on the bottom. The linkage should attach to the grips on the side that is towards the trailing edge of the blade. If it is flipped then it will work in the opposite direction.

Flipping the grips over is a mod that only works with a aftermarket radio not the stock e-flite. Maybe the previous owner had it set up this way?

Hope this helps! :)

[NutBird]

What servos are you using? I tried some HS-55s with the stock Tx and Rx with similar results. I went back to the stock servos. Hope this helps.