Epoxy woodie blade grips?

[Helibelly]

Hi, I tried to epoxy the blade grips of the standard woodies that came with my Hurricane (500mm blades).
I removed both of the retaining screws on the plastic blade ends, but they appear to be also glued on, so I didn't proceed any further. Perhaps they are already epoxied? Any thoughts?
Eric.

[Torq]

The consensus was the Stock blades are already epoxied.

See this thread:
http://www.helifreak.com/showthread.php?t=44085

[bstock]

Good to know!! Thanks for the question... and the link!

[Helibelly]

Thanks for the reply. I thought this might be the case, but wanted to make sure.
Eric

[Pinecone]

I had a tip over. Both blades snapped off just outboard of the grip pieces. The grip pieces are still solidly attached to the remaining bits.