9303 2.4Ghz throtle cut ???

[helimodelista]

I buy a new 9309 2.4Ghz and it have throtle trim analogic.

When i land the heli how i stop the engine?? By trim ???

Can i do a throtle cut?? Maybe idle-up 3 on other switch ???

Sugestions??

Thanks

[BarracudaHockey]

Yep, thats designed to use the trim, full back to cut, mid trim or so to idle w/o the clutch catching.

[Dré]

Hi helimodelista,

I don't know if this works but you can try this.

I have a PCM9X II and what I understand of it, is that is the same as yours, but no 2.4Ghz.

In the THRO TRIM menu I have the next settings

THRO CUT at -15%

And mine engine runs at Idle with a THRO TRIM of 48.

If mine THRO/pitch stick is below 10%, and I flip the TRN/SN ROLL switch (also the timer switch) it will activate a -15 trim on your servo and cut the engine.


I hope this helps


Greets


Dré

[fireup]

I want to be able to throttle cut while in throttle hold... Is it possible?

[Dré]

I don't think so.

I tryed it, but it the thro cut switch only works when thro hold is not active :(


The only thing that is possible (as for I can tell from the manual) is that you can cut the engine with the thro hold switch (set it the hold Pos to a - value)


Greets


Dré

[helimodelista]

In thro trim i can't find thro cut...

I now made a cut by mixture 3 in timer switch do a less position of thro servo.
When i turn on the radio, the thro is cut. I have to press time switch to idle position of throtle.
When i press time switch all position of throtle stick it lower servo position.

Until now i cant find aonther way.

[Dré]

Than your 9309 is different than mine PCM9Xii.

I real think the software would be the same , sorry about that :(


Just to make shure, mine Thro Trim screen looks like this (see attachment)