VBar, switching banks

[Flybar-less]

The live screen shows switch movement. How do you designate which bank is associated with the travel.

I read some where where you could switch between all four data banks. I would like to use 3 with a 3 position Aux channel.

[NTM]

I believe on the overview screen, set the bank selection to 0/1/2/3, then adjust the endpoints etc. on the aux channel in your radio. I'm only using bank 0 and bank 3 with a two position aux switch.

[Flybar-less]

Thanks,
I can get 3 modes with the 0,1,2,3 enabled. How intuitive.

[Klinger]

remember guys a lot of parameters are unique to each bank setting so if your making a change you want to all banks you must either use the copy function or make sure you make the setting in all banks. This has caught me more than once but always found it on the bench whilst flicking switches.

[th3tick]

I assume you had to run an extra cable from the Rx to the V-Bar Aux channel, right?

John

[Doug101]

Yes, and you will get banks dependent on the programing of the aux channel.

Aux %
0 - 25 = bank 0
25 - 50 = bank 1
51 - 75 = bank 2
76-100 = bank 3

So for a single switch you can only get 2 different banks. You can mix multiple switches or use a multi-position switch to get more banks

Doug