dave peers
11-03-2007, 07:34 PM
lots of head banging going on my end !
i cannot get the wc2 to allow me change state of the governor
the three position switch programing is straight foreward
selecting aux 2 channel on my rx channel 8
position 1 is off/off/off normal flight no governor
position 2 s off/on/off idle up 2 or speed 2
position 3 off/off/on idle up 3 or speed 3
however putting the governor in test mode i can only get speed1 /speed 2, by reversing the switch sense
i can only get speed2/speed3 ?
by adjusting A % low or high it can change the on off position for1/2-2/3 ,the same goes for B% !!!!
but heres the rub I CANNOT GET THREE POSITIONS so any body out there with a wc2 got any ideas ?
any input gratefully accepted with thanks
i cannot get the wc2 to allow me change state of the governor
the three position switch programing is straight foreward
selecting aux 2 channel on my rx channel 8
position 1 is off/off/off normal flight no governor
position 2 s off/on/off idle up 2 or speed 2
position 3 off/off/on idle up 3 or speed 3
however putting the governor in test mode i can only get speed1 /speed 2, by reversing the switch sense
i can only get speed2/speed3 ?
by adjusting A % low or high it can change the on off position for1/2-2/3 ,the same goes for B% !!!!
but heres the rub I CANNOT GET THREE POSITIONS so any body out there with a wc2 got any ideas ?
any input gratefully accepted with thanks