TX Stick Bling

[Rotorworkz]

Ok my friends I made some knobs for myself a long time ago and figured now I can have them produced Check out the

"Stick Bling"

Made to fit both Gimble thread sizes for Futaba and JR/Spektrum

Available in Blue and Red anodize
15mm or .588" in diameter
Unlike others We Knuled and Slotted sides for better grip for you pinch flyers
For you Thumb Flyers we didn't forget about you Check out the ring groves with no sharp edges unlike stock these babies almost massage your nervous thumbs

Lets not forget these are adjustable in height and can be locked down with a set screw

Now for the Meat and potatos these babies are going for
$8.00 a set
or $12.95 for 2 sets

[wareck51]

Hi!
I have just purchase this Stick Bling...
I have very little fingers,but I am a thumb flyer...
On my T9CHP Stock stick are to small and adjust to the minus position they are not easy for me...
When I saw your "Stick Bling" I take my bank card,and buy it ! (on heli direct)

I think they will come by 7 to 12 days (I live in France).

There are such think in France,I thinks there are a lot of people which they will be interest about this...

I will show my stick blink to maximum people near me !
And of course,give them a good adress to buy them !

:noteworthy

[th3tick]

I like the feel of these except for one thing. I wish there was a little bit of knurl to the top of them so I had a better grip. My thumbs feel like they're not secure, and going to slip off at any moment.

I likely need more time with them, and I do not dislike them. I may, however, take a file to the top and add a few grooves.

John