spock5643
11-12-2007, 03:12 PM
Trying to setup a 8103 to use Aux 2 for the governor. I can change the input select to enable aux 2 on the TH switch but have been unable to get movement of the switch even though I can set a PM mix for Aux2 to Aux 2 switch function works however when look at the servo movement screen the switch cause no action. Since the Gyro on this particular setup is set to Chanel 5 for standard or heading hold and the manual clearly states the gyro auto gain in there software says it should be Aux 2. When I put the Gyro on that switch I get the same problem no function from the switch. Any ideas?