DX7 Binding extra models

[doofus]

Once one models bound, how do you bind another rx?

[bullaculla]

You need to program a new model.

[doofus]

You need to program a new model.

Thanks for the reply. I've programmed a new model into the transmitter. How do I bind it to the new rx? If the new model is on the tx screen will it bind to that model automatically?

[bullaculla]

No, select the model, then turn off TX, insert bind plug into RX as per instructions, Power up RX, wait for flashing leds on RX, while holding down bind button on TX turn on TX power. continue to hold bind till RX lights are steady. After lights are steady, release bind button on TX, and remove bind plug from RX.
didn't your radio come with a manual? you can download them.

Here:
http://www.horizonhobby.com/Products/Support.aspx?ProdID=SPM2712

Also, after you have setup your new model, you should rebind so the RX knows your center sticks are and low throttle stick for failsafe.
Good luck! :)

[doofus]

No, select the model, then turn off TX, insert bind plug into RX as per instructions, Power up RX, wait for flashing leds on RX, while holding down bind button on TX turn on TX power. continue to hold bind till RX lights are steady. After lights are steady, release bind button on TX, and remove bind plug from RX.
didn't your radio come with a manual? you can download them.

Here:
http://www.horizonhobby.com/Products/Support.aspx?ProdID=SPM2712

Also, after you have setup your new model, you should rebind so the RX knows your center sticks are and low throttle stick for failsafe.
Good luck! :)

Thanks .. I've got the manual but couldnt find anywhere how to bind additional models.

[bullaculla]

Hey Doofus, did you get it working okay?

[Pinecone]

Hey Doofus, did you get it working okay?

That just SOUNDS wrong. :)

[bullaculla]

:lolol
Hey, I didn't choose his name for him ;)

[Pinecone]

Agreed. :)