Start fresh on DX7??

[diverjack]

Is there any way to start all over with the DX7? I think I screwed up, and I want to start fresh with it, as if it was never programed or anything. Is there a way to do this? I can't find it in the manual if there is a way.

Jack in Calgary

[boombreaker]

The fast way is to just create a new model. It will come up with all the defaults. You can then trash the other one at your leisure.

[AusAnt]

There is a data reset button which you get to by holding in the two programming down and select, then turning on the radio.

Jermo explains it very clearly in this vid from the Helifreak tech room http://www.helifreak.com/showthread.php?t=28681

What boombreaker suggested will also work fine, but if you don't want to create a new model, this is very fast too.

Ant

[diverjack]

Hey thanks, guys! Much appreciated. :)

[Danal Estes]

You should ALWAYS clear a given model memory before programming that memory. Even if it has never been used before. Process is in Jermo's video and/or in the manual.