Piro problems with DX7 and reflex

[heliboy88]

After switching from a 9C to DX7, i couldn't fly my reflex sim anymore. I've set a new model in the TX for the sim, and i changed the 'trainer' option in my Dx7 to PLINK/SLAVE(as told by others), the swash to 120ccpm(i've also tried airplane mode but the same happened). The heli model(any) did spool up, but when it lifted off the ground, it would start to piro(nose to the left). The piros were almost non-stop, it's not crazy fast tho, but even i input full right rudder, it just helped a bit but it would still piroed to the left.:mad::confused::mad:
Anyone can help? Am i missing something here or i did something wrong?
Hope someone can help get me back to the air(on the sim).
Thanks a lot in advance for any help i can get.

Best regards,
Rich

[theglennster]

Rich sorry I do not have a DX7 just a 9C but I think setting 120ccpm swash is wrong you need it setup like a plank or you will have mixing in there for starters.

Cheers
Glenn

[OKerbaul]

Hi,

You can settle a heli but with "1 servo" setup for swash. Planks work too.

Cheers

[heliboy88]

Thanks a lot guys, but i've tried that too without effect, the heli still piroed at lift off. Really don't know how to get this thing right. I've even tried to change the parameters, like changing the tail rotor diameter and everything, and the heli just improved a bit during lift off, but it would piro(often but not non stop) once flying.
Any idea please?

Best regards,
Rich

[OKerbaul]

Could be that your channel assignation is incorrect. Would suggest you try to use F8 and check what Reflex "sees" from your radio. Keep a plank setting or a 1 servo setup for heli, and go to F8. Move every stick and switch and note which one move which channel (there should be 8 channels). Then go to the channel assignation pannel, which is the one you see when you calibrate your radio, and note which channel was allocated to your tail and to your gyro. It could be the assignation is not correctly setup. From that window you can also reverse the channels (not on the radio) if necessary.

[heliboy88]

Could be that your channel assignation is incorrect. Would suggest you try to use F8 and check what Reflex "sees" from your radio. Keep a plank setting or a 1 servo setup for heli, and go to F8. Move every stick and switch and note which one move which channel (there should be 8 channels). Then go to the channel assignation pannel, which is the one you see when you calibrate your radio, and note which channel was allocated to your tail and to your gyro. It could be the assignation is not correctly setup. From that window you can also reverse the channels (not on the radio) if necessary.

Hi Olivier,

Thanks a lot for the advices. I'll try what you said and hope that will fix my long time problem.

Best regards,
Rich

[uniquexme]

i just tried that just now, using 1 servo normal swash. but i have to set the EPA to max for some channels before it will be detected.