HELP!! 9C with trex !!!!

[OHIOBOWHUNTER]

Anyone using a 9c futaba with a trex600n ? I can't seem to figure out which swash config. to use and what channels to plug into the receiver for the cyclic servos:arggg: any help deeply appreciated :noteworthy:noteworthy:noteworthy

[Y@nkee]

120 degree ccpm mix, chan 1 alieron servo, chan 2 elevator servo and chan 6 pitchservo.
Page 24 in the manual shows this btw.

[sbmon]

Do yourself a favor now. Go into every prog menu screen and make sure all mixes and programs are inhibited (inh). Futaba by default leaves some of these mixes active and it can really mess with you during setup if they are not turned off.
shawn

[BarracudaHockey]

HOV-PIT to INH
HOV-THR to INH
9C Non super- REVO to INH
9CSuper high/low pitch to MAN and NULL

Watch bobs videos on setting up the Trex 450 its the same pricipal

[johndoe25]

For the swash, go into paramaters, set to sw-3.