TRex 600N PRO w/upgrades- turn key [Archive]

3DBatixkid

11-15-2007, 10:52 PM

Unfortunately my 600N has gotta go. This heli is set up very well and is in ready to fly condition (minus receiver). Heli has 5 gallons through it and runs/fly excellent. The canopy has some dings and cracks in it but is still fine structurally. Setup is as follows:

- OS 50 hyper
- Hatori JK special pipe
- Futaba 9451 cyclic servos
- Futaba 9350 throttle servo
- GY 611 w/9256 tail servo
- Curtis ATG governer
- Fromeo 2600mah LiIon battery
- Smart-Fly adjustable voltage regulator
- HD switch
- Curtis 600mm Radix blades
- Align carbon tail blades

Upgrades on the heli:
- Curtis SuperStubz paddles
- Metal mixing arms
- Metal aileron and elevator levers
- Metal tail rotor bell crank
- Added frame connector between canopy posts
- Forward mounted gyro
- Carbon tail pushrod

Also included is a small align case full of spare parts. This includes parts from my 600E of which most are compatible with the 600N. Included are many extra screws, washers, ball links, gears, main shaft, paddles, etc.

Asking $1950 plus shipping (add paypal percentage if used).

Please contact me at 3dbatixkid@gmail.com or pm me with any questions you have.

Thanks for looking