My DX7 does not connect to AR-7000 sometimes

[jacky65]

Hi,
Sometimes my DX7 does not connect to AR7000.
I have tryed to rebind but it's the same problem.
Some days, there is no problem and another day (same temperature) I need to switch off the BEC and switch on again lots of times to have the servos working.
Does somebody know what's the problem ?
Thanks in advance
Jacky

[highland flyer]

Possibly your Tx is sitting to close to your Rx when you switch on as it can swamp the Rx.

I don't get a connection every time either, maybe 1 in 7 or 8 it won't connect.

This appears to be quite normal. Every time I re-do it with the Tx futher away no probs.

Also It makes sense to make sure your failsafe is set correctly as if not it may give you a hot start.

To make sure now I always give the Tx sticks a wiggle..

[jacky65]

Thank you very much !!
You are right, if I move the DX7 away, it's OK !
Rds,
Jacky