5003D seesaw question

[murp]

I noticed recently that my seesaw halves (MIK0935) do not mate completely at the ends. I have flown the heli succesfully several times now with no issue. The gaps are on the ends where the bearings seat in, I am afraid to tighten the 4 clamping bolts anymore for fear of stripping them. Anyone else notice this?

[Mercuriell]

There may be some moulding flash left preventing them from perfectly mating (:shock:) - when I assembled mine I gently sanded the halves on some 600 emery paper on a glass table to make sure they were perfectly flat - if your bearings are secure then probably no need to worry.