Honey Bee FP DX-6

[ih8nixon]

This is sort of a shot in the dark, but I had some extra stuff laying around and decided to try to set up a honey bee fp with an ar6000 rx, a brushless motor, dual tail motors, and an e-sky gyro( the regular one not the HH). I am currently trying to figure out the throttle and rudder mixing. The problems that arise are trying to get the the tail motors stopped while there is zero throttle input, getting the tail motor to correct the torque from the main motor with the correct mixing, while having the rx able to send a signal that will allow the gyro to arm itself (the signal required causes the tail rotors to be at half throttle).

My best attempt so far has been setting up a custom mix between channels 1(throttle master) and channel 4 (slave tail motor) and Setting this on F1 (top left switch) using it on the switch allows me to arm the gyro.I have this set so that the offset is at full throttle on the main motor. The problem arises when I have it set up so that the tail motors are stopped at zero throttle the mixing is off and when I have it set so that the mixing is near correct the tail motor spins at zero throttle.

Any suggestions would be greatly appreciated thank you.