jsuns
11-28-2007, 10:16 PM
Can anybody point me to the instructional photos for replacing a toggle switch on a Futaba 9CHP TX? I've done it once, and remember seeing numerous steps of instructional photos, but I can't remember where I had located the illustrated instructions.
Thanks!
DavidH
11-29-2007, 10:31 AM
Which one you have to replace? The switches are mounted on circuit boards. The switches that are each top corner of the radio was fairly easy to change. Just take out the board that is holding both switches.
Then use some desoldering braid and remove the old switch. Then install the new switch and re solder the contacts where they stick thru the board.
The switches across the front of the radio are a little more difficult to remove. That is about the only difference.
David