Binding question

[Black hawk Down]

New to this,
in the rx, I have power to it, where does the binding plug go in the rx, does it matter which slot?

[pcool69]

I use the switch harness that came with the radio. Plug the battery into the harness and use the charging lead to bind the system.

[Skiddz]

On my AR6100s, I put the bind plug into an open slot and on my AR7000, I use the lower, horizontal slot.

[Pinecone]

The instructions say to use the Batt port. So I have been following the instructions. :dontknow

But if Skiddz says any port will work, I will have to try that.

I don't have a switch harness, so can't try that. :) Spektrum Module in JR 9303.

[fireup]

I don't think any open slot will work, it has to be the Batt slot. At lease that's what I've notice when I plug in Aux2 instead of Batt.

[poptart]

ya i put the bind plug in the battery port and plug my battery straight into the throttle port

[Skiddz]

To be honest, I'm not sure which slot on the 6100 I'm using. It's the one I can reach without pulling the Rx from the heli so it very well may be the batt slot.

[Pinecone]

Yeah Kev, lead us on with false info. :)

[DebianDog]

To be honest, I'm not sure which slot on the 6100 I'm using. It's the one I can reach without pulling the Rx from the heli so it very well may be the batt slot.


To quote Joe Helicopter:
"A $2 servo extension in to the battery slot and a zip-tie to the heli makes your re-bind a lot easier"

No reason to move the Rx or have to try and reach in there.:thumbup:

[darryn]

So to confirm:
If I don't have a switch harness, I plug the bind plug in the battery port of the receiver, and plug the Rx pack into the throttle channel (channel 1)?

TIA

[Dave M]

you can plug the reciever pack into any open slot... then bind plug into battery slot.:thumbup:

[Pinecone]

Bind plug in Batt port.

Power into any other port.