Is anyone running Radix mains on their 6003D?

[t-rexn8]

Hello. I ran a quick search but I could not find a definate answer for my question.

I installed some Radix 600 main blades on my converted T-600 with Mikado 600 3D main grips and I noticed that they are too loose without the included spacers. With the spacers it seems almost too tight.

Does anyone have any experience with this?

I think its ok but I just like to check with others that have used these parts before.

Thanks again Helifreaks!
I could post a picture if anyone is interested. I was getting ready to post one in the flybarless section too.

[Eyon]

its just the really tight tolerances with mikado grips. they are 14mm grips, so in theory you will need a top and bottom spacer. in reality only 1 spacer works fine, blades will be offset by 1mm, but there is no difference in flight

[LITHIUMSTATIC]

its just the really tight tolerances with mikado grips. they are 14mm grips, so in theory you will need a top and bottom spacer. in reality only 1 spacer works fine, blades will be offset by 1mm, but there is no difference in flight

Did the same thing. Just one washer.

[Ticidytoc]

Once you get 2 spacers in there she gets stretched out and the next time a blade swap is in order they go in like butter, well kindda' like butter. :wink:

[t-rexn8]

Cool thanks Ticidytoc.

It definately seemed to fit more square with both spacers installed. With one spacer it seemed as though it would not be square on the inner part of the grip, where it meets the blade root. Just want to make sure guys are actually running them with both spacers installed.