solvik
12-02-2007, 09:50 AM
I have just installed Align RCE-G600 governor in my Trex 600 Nitro.
I have Futaba 9CP Radio i i dont understand quite how to set this govenor up in my radio.
In my setup i have one govenor off/on switch that works. Ch 7.
And in Governor meny in advanced mode i have following settings:
Govenor:
(INN)
RATE UP 0%
CNTR: 80%
DOWN: 100%
SW: E Idle Up
But when i put the govenor on and flip on idle up 1/2 it is the same as before.
I have Futaba 9CP Radio i i dont understand quite how to set this govenor up in my radio.
In my setup i have one govenor off/on switch that works. Ch 7.
And in Governor meny in advanced mode i have following settings:
Govenor:
(INN)
RATE UP 0%
CNTR: 80%
DOWN: 100%
SW: E Idle Up
But when i put the govenor on and flip on idle up 1/2 it is the same as before.