rond
12-09-2007, 07:20 AM
I have for sale an excellent Blade CP Pro with:
Eflite Heading Hold gyro, brand new ran less than 4 packs
Brushless Eflite Park 370 Motor
Eflite Brushless ESC
Eflite 800 mah 3 Cell Lipo
Eflite Lipo Charger
Micro Heli CNC Swashplate
Carbon Blades
GWS upgrade direct drive tail motor (per RC Heli article)
GWS speed controller to run tail motor-5 amp
3 S-75 servos
Brand new canopy (yellow)
Eflite wooden 3D blades NIP
Skid set NIP
Blade grip set NIP
Mixing arm set NIP
8 tooth pinion NIP
Flybar
Couple more misc. parts as shown
The heli has everything for a maximum 3D setup. Last time I flew it, I tipped it over in a gym. Put on new main shaft, new head axle, new boom, new carbon blades and test flew with everything smooth but found a stripped gear tooth in two of the servos. I was able to hover but these two servos need replacement gears. Everything else is ready to rock. I ran this on a Spektrum rx and I gave away the original TX, so it is not included.
$175.00 shipped in the CONUS
Thanks,
Ron
Eflite Heading Hold gyro, brand new ran less than 4 packs
Brushless Eflite Park 370 Motor
Eflite Brushless ESC
Eflite 800 mah 3 Cell Lipo
Eflite Lipo Charger
Micro Heli CNC Swashplate
Carbon Blades
GWS upgrade direct drive tail motor (per RC Heli article)
GWS speed controller to run tail motor-5 amp
3 S-75 servos
Brand new canopy (yellow)
Eflite wooden 3D blades NIP
Skid set NIP
Blade grip set NIP
Mixing arm set NIP
8 tooth pinion NIP
Flybar
Couple more misc. parts as shown
The heli has everything for a maximum 3D setup. Last time I flew it, I tipped it over in a gym. Put on new main shaft, new head axle, new boom, new carbon blades and test flew with everything smooth but found a stripped gear tooth in two of the servos. I was able to hover but these two servos need replacement gears. Everything else is ready to rock. I ran this on a Spektrum rx and I gave away the original TX, so it is not included.
$175.00 shipped in the CONUS
Thanks,
Ron