8mm One Way Gear Shaft

[sammy64]

I have done the upgrade to the 8mm One Way Gear Shaft Set (204575) and the upgraded the Motor mount (204581), also a new hub and front gear. After this upgrade from the original i have about 1MM/1.5MM of up and down play in the shaft. I have put both Washers in the outer sides of the one-way gear and even pulled the top one out as per Gaui Instructions ( http://www.gaui.com.tw/en/H550_Instruction_Manual.pdf ) Page 4 . just wondering if this is Normal.

Sammy

[mjdee14]

Sammy..

Look at the Finnless videos in the sticky section....he talk about the one way bearing and states the gear should have some play...it was designed that way.

I think it's in the fuse 2 video.

http://video.helifreak.com/?subpath=finless/hurricane550&filename=framesp2.wmv

Try the above link

[sammy64]

I have seen the video's. The one-way dont move, its the shaft that moves up and down. I think i need to change one thing in my last post. The shaft only moves about .5MM to 1MM, Not 1MM to 1.5MM