KarbonBird
12-13-2007, 03:49 PM
All has been going well with the build of this heli, however I am now trying to install the motor but it won't fit into the slot. The problem is being caused by the two (Countersunk, flat head) screws on the inside which are not flush with the aluminium frame, but protrude a few mm above it. It doesn't look like the holes have been countersunk to accommodate the screw.
Anyone else had this problem? Is there a solution for it - I don't want to take the whole thing apart again!
Anyone else had this problem? Is there a solution for it - I don't want to take the whole thing apart again!