flag8r77
12-16-2007, 10:59 AM
Just picked up a pair of G Force mixing arms....the manual states to not over tightnen the arms onto the seesaw hub. How loose should these be? Loose enough to not stay in place (able to fall to one side or another) or tight enough so you can move them by hand but they won't fall to one side or another freely?
EricW
12-16-2007, 12:32 PM
Same goes for any rotating connection:
You want close to "zero play" in all directions and the rotation has to be as smooth as possible.
So probably not stay in place in your case, without play in all other directions.
I always tighten up till they don't fall (with locktite applied) and then slowly loosen up till they move freely.
Hope this helps.
Eric