japhar81
12-20-2007, 08:38 PM
Hi guys, maybe Im just an idiot, but I cant figure this out to save my life..
Im using my 14mz with my miniature razor 600e. G3 receiver, channel 1 (throttle) is a Castle Phoenix hv-85. To get the thing to arm, it has to see 0 throttle for 4 seconds. Easy enough if I drop my throttle trim all the way down. Its also supposed to give me a solid light when it sees full throttle. It doesnt. Even if I turn the trim all the way up, it still doesnt.
I tried turning off trim on the throttle channel altogether (Under function, set the switch to null) and adjusting ATV limits from 135 to 100, with travel at 100 as well. I thought this combined with a -100%/100% linear throttle curve would mean that my stick literally goes from 0 to 100 and trim doesnt apply. Instead, it wont arm at low stick, or see high stick.
Can anyone tell me where Im going wrong here? The castle is programmed to heli: fixed end points if that matters..
Thanks!
Im using my 14mz with my miniature razor 600e. G3 receiver, channel 1 (throttle) is a Castle Phoenix hv-85. To get the thing to arm, it has to see 0 throttle for 4 seconds. Easy enough if I drop my throttle trim all the way down. Its also supposed to give me a solid light when it sees full throttle. It doesnt. Even if I turn the trim all the way up, it still doesnt.
I tried turning off trim on the throttle channel altogether (Under function, set the switch to null) and adjusting ATV limits from 135 to 100, with travel at 100 as well. I thought this combined with a -100%/100% linear throttle curve would mean that my stick literally goes from 0 to 100 and trim doesnt apply. Instead, it wont arm at low stick, or see high stick.
Can anyone tell me where Im going wrong here? The castle is programmed to heli: fixed end points if that matters..
Thanks!