kraaijer
12-21-2007, 03:42 PM
Well I got one too.
Started the build yesterday and I've got the frame and tail done sofar.
It's been uneventful really. An interesting build compared to Trex.
I have the KO Pro 2123 on cyclic and possibly on tail as well if I can figure out if it will work correctly with the ds760 gyro I plan on installing. It's a superfast servo, supporting 7.2V just like the DS760 so I can run everything of off the 2S receiver lipo except the receiver itself (AR9000).
I haven't decided yet on motor, but I think it will be the Hacker A40-10L with the Jazz controller.
Where do you all place your components (ESC, BEC, receiver, receiver lipo, gyro), in the manual it seems as if there is a full bottom plate where they show the layout of the components, but I sure don't find it in the box...
Started the build yesterday and I've got the frame and tail done sofar.
It's been uneventful really. An interesting build compared to Trex.
I have the KO Pro 2123 on cyclic and possibly on tail as well if I can figure out if it will work correctly with the ds760 gyro I plan on installing. It's a superfast servo, supporting 7.2V just like the DS760 so I can run everything of off the 2S receiver lipo except the receiver itself (AR9000).
I haven't decided yet on motor, but I think it will be the Hacker A40-10L with the Jazz controller.
Where do you all place your components (ESC, BEC, receiver, receiver lipo, gyro), in the manual it seems as if there is a full bottom plate where they show the layout of the components, but I sure don't find it in the box...