GY611 and 600N

[billias]

Hi,

I have setted up the gyro like the manual sais! and what i found is that my End points on Gyro are at 89%! is that a problem on my setup?
I used the horn with 4 Holes! and i used the Third from the center! (as the manual shows.

Thank you
Bill

[scottc]

if nothing is biding then it should be good to go.

[invertmast]

having your endpoints that low isn't going to give you very good performance and will shorten the life of your servo..

For best performance out of the 601/611 series here's what ya need.

end points set to 110-120% No more no less
Put your ball on the servo arm to allow for full movement w/o binding.

ATV and rate gains at 30-37% . I have both of my gains set at 37% and the limits at 115 for both sides. No problems with tail blow out ever.

[billias]

[quote=invertmast;485139]having your endpoints that low isn't going to give you very good performance and will shorten the life of your servo..

For best performance out of the 601/611 series here's what ya need.

end points set to 110-120% No more no less
[quote]

That is what i remember from an older post! thats why i started the thread!
on my rappy (raptor) i had 117
and my AVCS is 34% from rappy!

Thank you for your time PPL :)

[Street Flyer]

I had that problem on my 611. Move the ball in one hole (toward the output shaft) ,and you should be good.