Help fixing Logo500 3D tail boom

[erwin_seow]

Hi all. Just received my logo 500 3D. I am having problems attaching the tail boom to the body. The tail boom diameter is about 20mm, where as the hole in the body is around 22mm. I cannot seem to tighten it to clamp the boom. Am I missing something here? Thanks!

[BruceW]

It looks like your boom blocks are just too big and not the correct ones since I can see they are all the way closed. Even with the spacers for the 6003D installed I would guess that it would close better than that. You did leave the spacers out, correct? They are only needed for the 600 3D.

Looked through the parts catalog and there are no other blocks like these in different sizes. Also, the boom on my 500 is 20mm at both ends.

[erwin_seow]

Thanks Bruce for your help. Yes. I guess that the boom holder is not the correct ones. I am not sure how this could happen though....

Anyway, spoke to the shop about it and they are sending me a replacement part soon...

Hopefully, other new logo 500 owners do not face the same problem...

Thanks!