Setting expo in Phoenix

[kamtsa]

What is the recommended way to setup expos? Setting expos in the TX and leave Phoenix linear or the other way around?

(I would prefer to setup the expo in the TX so it matches the setting of the real models).

Thanks,

Kam

[Ade_Law]

either works just fine.

Ade

[George1234]

If you tend to set different % for different models, you're better off doing it in Pheonix, and leaving your TX at 0%. That way you don't have to keep changing TX programming for every model.

George

[kamtsa]

If you tend to set different % for different models, you're better off doing it in Pheonix, and leaving your TX at 0%. That way you don't have to keep changing TX programming for every model.

Good point, thanks. Does 30% expo on Phoenix and 30% expo on DX7 mean about the same thing?

Kam