Solid G Set Up.

[donskills]

I among others have noticed that the Solid G is quite noise sensitive. So it is good practice to keep the amp and sensor as far from servos etc as possible. Also, run the cables to and from the amp and sensor separately .Guess how I know!! I was experiencing twitches, especially when punching collective suddenly (all 3 servos moving at the same time). This bled over to the sensor cable when I had the cables bundled. After rerouting and separating the cables, all is well!!

[MoF65]

Just an other question about the SolidG setup.

On Bob's setup guide for the SolidG in the T-rex 500 he could choose, among others, T-Rex 600N and T-Rex 600E. On mine I can only select a T-Rex 600. Does anyone know why it is like this?

I got the answer from CY myself:
The gyros with the green stickers are the gyros that were sent back to the manufacturer for cleaning. They got the green stickers along with a version of the program that had the 600N parameters installed in the program. The one without the green sticker (they have a white sticker with “ inspected and cleaned by CJ Youngblood Ent” on the box) were hand cleaned by us and have only the trex 600 (ideal for trex 600E) in the program.

Morten