Socal500
12-30-2007, 12:52 AM
HELI SOLD. 401 Gyro and 9257 still available. See last post for details.
NO MOTOR, ESC, RX or Main Blades
Approximately 30 flights total with no crashes.
http://www.socalsurfs.com/trex.jpg
TREX SE New V2 with Grip Flip Mod ($270 kit only / Mod Priceless)
Futaba 401 Gyro ($140)
Futaba 9257 ($54)
4 Hitec HS 65MG servos ($36 each - three installed on cyclic and one spare)
Align FG Canopy (part of kit - installed)
Main shaft bearings upgraded to boca ceramic ($20 10 flights)
Gates tail drive belt ($5 apprx. 5 flights)
2 stock belts ($10 one NIP, one used 25 flights)
Grooved idle pulley ($3)
1 Boca Ceramic Bearing for tail ($7 ordered 1 instead of 2 (NIP))
CF Tail Blades ($11 installed)
Stock tail blades (Unused)
3 Main Shafts ($8 NIP)
2 Feathering Shafts ($6 NIP)
2 Tail rotor shaft/pulley ($8 NIP)
2 220 MM silver flybars ($5 NIP)
Two sets of Trublood Dampeners ($5 - 1 installed, 1 NIP)
A few used parts like the original main shaft bearings and any odds and ends I dig up.
!!!500 pp/shipped prices out to $700.
I will break up as listed below.
$350 for trex with cyclics and all spare parts listed.
$150 for 401 and 9257 alone. Will not break up the two.
For additional $50 I will ship in a large flight leader case
SHIPPING AND PAYPAL INCLUDED TO LOWER 48 VERIFIED ADDRESS ONLY
NO MOTOR, ESC, RX or Main Blades
Approximately 30 flights total with no crashes.
http://www.socalsurfs.com/trex.jpg
TREX SE New V2 with Grip Flip Mod ($270 kit only / Mod Priceless)
Futaba 401 Gyro ($140)
Futaba 9257 ($54)
4 Hitec HS 65MG servos ($36 each - three installed on cyclic and one spare)
Align FG Canopy (part of kit - installed)
Main shaft bearings upgraded to boca ceramic ($20 10 flights)
Gates tail drive belt ($5 apprx. 5 flights)
2 stock belts ($10 one NIP, one used 25 flights)
Grooved idle pulley ($3)
1 Boca Ceramic Bearing for tail ($7 ordered 1 instead of 2 (NIP))
CF Tail Blades ($11 installed)
Stock tail blades (Unused)
3 Main Shafts ($8 NIP)
2 Feathering Shafts ($6 NIP)
2 Tail rotor shaft/pulley ($8 NIP)
2 220 MM silver flybars ($5 NIP)
Two sets of Trublood Dampeners ($5 - 1 installed, 1 NIP)
A few used parts like the original main shaft bearings and any odds and ends I dig up.
!!!500 pp/shipped prices out to $700.
I will break up as listed below.
$350 for trex with cyclics and all spare parts listed.
$150 for 401 and 9257 alone. Will not break up the two.
For additional $50 I will ship in a large flight leader case
SHIPPING AND PAYPAL INCLUDED TO LOWER 48 VERIFIED ADDRESS ONLY