Speed stick 3D
01-05-2008, 03:32 PM
Hi I have a Swift 16 RTF heli and it needs to go quick.. I need to get either a 50 size nitro or a T-Rex 450 Se or SE V2.. Also looking for a HDX 500 SE for trade or i will sell for 700.00.. Everything included is over 1300.00
Swift 16 Kit
Upgraded Metal Head Block
Upgraded Hardened feathering Shaft
Outrunner 600 + Motor
Align 75 Amp esc
3 Futaba 3151 Digital Servos
1 Futaba GY 401 Gyro
Maxwell 831 MG Tail Servo (.08 @ 6.0 V .10 @ 4.8 V)
Helimax 530 mm CF Blades (nice blades)
T-Rex 600 Head Button
T-Rex 600 Landing Gear set
1200 mAh sanyo reciver pack
Hitec Switch Harness
Thunderpower 5 Cell 3850 Li-po
The Lipo was in a small crash and given to my by a friend.. I took it to thunderpower and they repaired it and re-covered it.. It has alittle over 100 cycles and is still giving me 6 min 3D flights running 1850 RPM stunt mode head speed.. The Helicopter was in a small crash because the reciver pack fell out and i lost control.. It broke the canopy and pretty much shattered everything stock on the tail.. I have ordered a canopy for it and the tail unit is off a T-Rex 600.. I used sheet aluminum for shims becuase the T-Rex 600 boom is bigger than the stock swift one.. To do this because the tail case is longer than the stock one i had to cut the boom down about a alf inch.. The tail works great and you cant even tell that it wasnt made for it....I will post pics upon request.. i want to get a smaller electric where i can get parts for locally.. Lokking for an align 450 SE or SE V2 for trade...maybe even a HDX 500 SE
Thanks Speed stick 3D :D
Swift 16 Kit
Upgraded Metal Head Block
Upgraded Hardened feathering Shaft
Outrunner 600 + Motor
Align 75 Amp esc
3 Futaba 3151 Digital Servos
1 Futaba GY 401 Gyro
Maxwell 831 MG Tail Servo (.08 @ 6.0 V .10 @ 4.8 V)
Helimax 530 mm CF Blades (nice blades)
T-Rex 600 Head Button
T-Rex 600 Landing Gear set
1200 mAh sanyo reciver pack
Hitec Switch Harness
Thunderpower 5 Cell 3850 Li-po
The Lipo was in a small crash and given to my by a friend.. I took it to thunderpower and they repaired it and re-covered it.. It has alittle over 100 cycles and is still giving me 6 min 3D flights running 1850 RPM stunt mode head speed.. The Helicopter was in a small crash because the reciver pack fell out and i lost control.. It broke the canopy and pretty much shattered everything stock on the tail.. I have ordered a canopy for it and the tail unit is off a T-Rex 600.. I used sheet aluminum for shims becuase the T-Rex 600 boom is bigger than the stock swift one.. To do this because the tail case is longer than the stock one i had to cut the boom down about a alf inch.. The tail works great and you cant even tell that it wasnt made for it....I will post pics upon request.. i want to get a smaller electric where i can get parts for locally.. Lokking for an align 450 SE or SE V2 for trade...maybe even a HDX 500 SE
Thanks Speed stick 3D :D