KarbonBird
01-06-2008, 07:08 AM
Just checked the mesh and alignment of the GSR and found one side of the clutch is lower than the other. After several attempts to correct this problem I was able to line the clutch and bell BUT then there was way too much tolerance in the meshing to the main gear (unless it should have noticeable play in it normally).
One thing though the clutch spins freely and doesn't bind at all despite the one side being about .25mm longer. Is it self-aligning perhaps so this doesn't matter?
Is there a solution to this perhaps - maybe another gasser type helicopter has similar issues?
One thing though the clutch spins freely and doesn't bind at all despite the one side being about .25mm longer. Is it self-aligning perhaps so this doesn't matter?
Is there a solution to this perhaps - maybe another gasser type helicopter has similar issues?