What tools should I buy

[police1]

More money then brains at this point....

I just bought my second rc heli...first one was a e-sky lama v4 co-axial......crashed it into the coffee table.... waiting for repair parts.

My second RC is a T-Rex 450s with 430L 3550KV Brushles motor, RCE BL35X ESC, futaba GY401 Gyro with S9250 Digital Servo along with the hitec HS-65HB Micr servos.

I bought all the required crash gear and a set of training wheels and some replacement parts. using ThunderPower lipo 2100mah and the Futaba 6ex Transmitter.

After watching all 23 videos from Finless I am starting to realize I need to spend more money on tools. Can someone tell me what I need to buy that won't be included in the kit....that will be absolutely required for the initial build.

I plan on ordering an entire tool chest full of all the latest and greatest stuff but that will be more for the later part of my flying or crashing experience when I start doing repairs.

For now I just want to get the bird built and start learning the very basics.


WHAT GOOD IS MONEY IF DON"T SPEND IT!!

E-SKY LAMA V4 Flights 1 Crashes 1 air time 2.5 seconds
T-REX 450S Will arrive this week :happyd

[MarkD]

Decent set of hex drivers (you can use the supplied L shaped ones but they won't last long)
Ball Link Pliers
Pitch Gauge (As a newbie you need this until you can see by eye and understand what your looking at)
Vernier Gauges (not nessesary but makes setting up the link length easier)
Soldering iron and solder (Min 35Watt)
Long nose pliers (Handy if needed)
Cable Ties


The list is endless as you will find out when you start to maintain the bird :D