help with x9303 rec. channel assignments

[scooby61]

just installing my 9303 in my rex600 i can't find in the manual what channel to assign for pitch, gyro gain, and governor. i just left the chat room and could not get a definitive answer.

[Finless]

OK same a JR assignments so here they are

1 = throttle
2 = Aileron
3 = Elevator
4 = Rudder (goes to the gyro's rudder channel input)
5 = Gear which can be used for gyro gain but you must use end points to adjust gain as you cannot assign the gyro menu to this channel.
6 = Pitch (labeled AUX 1)
7 = Aux2 you can also use for gyro gain if you want. You CAN assign the gyro menu to AUX 2 so if you want to use the gyro menu use this channel

OK now this might help you out. I used a X9303 for the Trex500 builds. Here is a X9303 radio overview I did for it.

http://video.helifreak.com/?subpath=finless/x9303&filename=x9303.wmv

Also during the setup of the 500 I use this radio for servo setup etc. So go see some of those videos in this forum here:
http://www.helifreak.com/showthread.php?t=53304

Enjoy!
Bob

[scooby61]

thats what i was looking for thanks but i saw in another forum that you must use a certain aux port for the governor gain is this true?

[scooby61]

oops i finally found it in the manual gear channel for the gov. its a bit of a learning curve switching from futaba to jr i just have to figure out how to navigate through the radio. thanks again for your help