Help Binding Spektrum receiver with align 2n1

[deanholmes]

I'm building a 600n and now at the stage of servo install.

I have a JR 9303, I just purchased the DSM2 module with 9ch receiver.

To bind the receiver to the transmitter, you are supposed to have the battery hooked up to a switch and the bind plug in the charge lead on the switch.

I bought the 600n combo package with engine and Align 2n1 with Align battery.

I do not have a switch, I plug the align battery to the align 2n1, then the 2n1 to the battery socket on the 9ch receiver. Now I have now where to plug the bind plug. The bind plug on its won won't work has you need power going to the receiver.

Any ideas? of do I have to go by a traditional switch with charge lead(which is no good for the align battery)

Thanks
Dean

[ClayK]

You can plug the power from the battery into any channel on the rx. You can then use the battery slot on the rx for the bind plug.

[deanholmes]

Thanks that work great.

I have one other semi related question, I have the JRG7703d Gyro combo. It came with the JR8900G tail servo. Is this servo 6v align 2n1 compatible or do I need a step down lead to 4.8v?
Thanks

[Made2Fade]

Hi mate, it seems the servo is 4.8 volt only so you will need the step down
http://www.jrradios.com/Products/TechnicalSpecs.aspx?ProdID=JRPS8900G

Lee

[Pinecone]

And on the 9 ch you need to use teh Batt/Bind slot, not the other one. That Rxs has two batt slots, but only one supports binding.