HDX450 Noob. Help me plase.

[yongary]

Everything is built and installed except receiver. I have a JR790 scanselect SPCM rx. I connected aileron,throttle,pitch,elevator to the receiver but not rudder connector. It looks like the rudder connector is a little bit bigger than other connectors so I can't connect it to the receiver. What should I do? btw, I'm using futaba 240 gyro w/ hitec 81 tail servo.

[gadawg58]

Everything is built and installed except receiver. I have a JR790 scanselect SPCM rx. I connected aileron,throttle,pitch,elevator to the receiver but not rudder connector. It looks like the rudder connector is a little bit bigger than other connectors so I can't connect it to the receiver. What should I do? btw, I'm using futaba 240 gyro w/ hitec 81 tail servo.
The GY240 Gyro should plug in just fine to the rudder channel on your receiver then the servo into the gyro. Make sure you have the correct lead coming off of the gryo as the female(larger lead) plugs into the servo and the standard servo style lead goes into the receiver. I've never seen one that didn't fit. Hope that helps.

[damyxz]

The futaba connector will not slide into the JR receiver because of the flange on the side of the connector. You can change the connector or sand off the flange and it will slide in perfect.