help 9303 setup pitch/throt curves

[scooby61]

just read the post about setting this thing up first before the mechs on the heli. too little too late but i'm struggling to setup and program this radio if any one can give some throttle and pitch curves. and how they setup their governor and gyro settings i would appreciate it greatly. i have the 600n sport with the following equip.

os 50 hyper
gy401
curtis youngblood atg (gov)
servos 9252's
2in1
and of course the x9303 with 9 ch rec.

[deanholmes]

What part are you stuck with?

I assume you have mechanical center Bob White(Finless) covers this great in his videos, can not stress enough how important that is. I would strip the heli down again to get center. I had too after I got bit with the curve lever.

The in normal I do -5 +11, idle up 1 &2 I do -11 + 11

[scooby61]

i think maybe i got bit by the lever too because when i went for my first test flight it wasn't too far off. i landed and because it was alittle jumpy in normal i softened up my pitch curve and next test it was like my sturff had been completely reprogrammed. i'm mostly having trouble with the gyro and gov setup. i have my governor setup for diff headspeeds in all three flight modes. and i also wanted to have a switch to turn the gov off but when i try to assign it you can't tie it to the same channel. i guess thats the diff between jr & fut.
with futaba you can assign any switch you want.

[invertmast]

where in virginia are you? i'm in harrisonburg, if your close, i can help you out with it this weekend.

[scooby61]

i was in front royal not too far away from you but i just moved to manassas about 3 mo. ago.

[invertmast]

I can give you the details of my 600N pro for the curves off my DX7... but the gyro i can't help ya with cause i run a 611.

but if ya go in the finless section he has some good vids on setting up the 401

[scooby61]

any thing you've got would help i don't seem to be getting any one elses interest with this post thanks.

[cudaboy_71]

try asking a specific question. i'd like to try to offer some advice. but, i really don't know what the particular problem you're having is. is it the gov menu? setting up the head? setting up the gyro? *shrug*

i don't have that gov...but, i've run the 9303, 401 and 600N.