Programming CC60 for Hyperion H3025-10

[jnnc]

Hello

Need help programming my CC60 for the Lepton, my motor is the Hyperion H3025-10.

This are the settings that configured

1-1 -Auto-Lipo (Cutoff Voltage)
2-4 -Insensitive ( Current Limiting)
3-5 -Brake Disabled ( Brake Type ) .... OK this one was easy :)
4-2 Fixed throttle ( Throttle Type)
5-2 Standard advance timing ( Electronic timing advance)
6-2 Soft Cutoff (cutoff type)
7-1 Very soft start (Soft Start)
8-1 13Khz (PWM switching Rate)

Are this the best settings for it ?

[Rush]

- i would set lipo cutoff to 12V manually if 4S.
- Check your timing advance. i think the hacker may need to go high timing as its a low KV motor.
- PWM switching rate should be indicated in the motor specs. may want to check out empirerc site just to make sure.

Hope the above helps and let me know cause i'll be setting up the same esc by next week i hope.

Regards

[jnnc]

Thanks… Rush

But I´m using the Hyperion, as mentioned. Do you think the same setup for the Hacker, will work fine ?
By the way the site you mention, couldn’t find anything, can you be more specific.

I´m confused in this 3 options, Current Limiting, Electronic timing and Switching rate, the switching rate for my motor I think it´s 8 Khz, but can only chose 13, 26 or 52.

Regards

[Rush]

On the hacker probably most of the same settings as its essentially a 600KW motor as well.

For heli mode, i normally use:
Current limiting - insensitive
Electronic Timing - probably high for low KV motors (but you really should ask more people on this). high timing will be less efficient and consume more power/hence more heat
Switching rate: - cant answer this one. cant see it on the 3025-10 spec sheet. might want to email empire rc. link below to the motor specs. but i cant find the data on it.

http://www.empirerc.com/z3025spec.htm

PS. - a few threads down from this one, topic on a 3025-10 being burnt out. Finless recommends that you run high timing for the 3025-10. Cant hurt...

[jnnc]

Tks Rush for all your attention !!

I probably have more questions when I put it in gov mode !!

For now I’m going to wait for my FP 3700 4s to arrive, I’m running FP 2500 3s from my Minititan.

Best Regards

[cybinary]

Finless has a great set of videos about using the built in Gov mode on CC ESCs... I highly recomend watching them as I had to figure it out before he did the videos on my Rex450. Its well worth it though, my 450 flew great in Gov mode, just cut down my flight time a bit since I was running a constant 2800 HS. :)

Here is a link to Finless's Videos...
http://www.helifreak.com/showthread.php?t=36194